This can be easily done by threading the nut onto the end of a Button Head Cap Screw, and then press them into place by hand. Install (2) Nuts into the hexagon countersunk hole on each Clamping Miter Bar. This Flat Head Cap Screw will be tightened in later steps to expand the Clamping Miter Bar to create a tight fit in the miter slot. Repeat for the second Clamping Miter Bar. Loosely thread an Oval Nut onto the Flat Head Cap Screw using an 1 /8″ Hex Key. Insert a Flat Head Cap Screw through the center countersunk hole in the Clamping Miter Bar®. YOU WILL ALSO NEED: Combination Square (Not included) When lowered, the StealthStop is fully below the surface of the track and out of the way. It does require the 1/8″ Hex Key to lock the stop in place.
The StealthStop ⑪ is tool-free for raising/lowering the flag, and for micro-adjusting position. STEALTH STOPSĪT THIS POINT YOU WILL NEED: - Hex Key, 1/8″ R Refers to the instructions for assembling the Right side. L Refers to the instructions for assembling the Left side. Video tab towards the bottom of the product page. Scan the QR code above to watch the video or visit under the Please detinning which AutoScale you purchased. Woodpeckers AUTOSCALE Miter Sled Drop Zone Base
